Table of Contents
Advertisement
Remote control of the Surround Decoder
General information
The digital surround decoder can be controlled using the
F11 remote control handset, or the F1 system remote
control unit. If you are using the F1 handset, it must first
be switched to Hi-Fi mode.
The decoder receives its remote control commands via
the R
master device. Press the
LINK
switch it on; it switches itself off when the Master device
is turned off.
In the drawings some of the buttons are filled in
(
); these are the ones which are required for
remote control of the decoder. The other buttons have no
effect on this unit.
button to
(F11/F12)
bzw.
(F1)
8
F1 only: switch the handset to Hi-Fi mode.
Direct source select button
Note:
The F1 remote control handset also in-
cludes the source buttons
and
.
(F11) and
select the same source device.
Volume control rocker
Switches all loudspeaker outputs on and off
alternately.
F1 only: Switches all loudspeaker outputs
off.
Multi-function button:
Brief press in stereo mode:
Switches over to surround mode.
If the decoder is switched off,
it is automatically switched on again.
Brief press in surround mode:
Switches to the next AV source
which is assigned to the source button
in the 'Source Setup'.
Long press in surround mode:
Switches to the previous AV source
which was assigned to the source button
in the 'Source Setup'.
Brief press in surround mode:
Switches to stereo mode.
Toggles volume-dependent tone correction
(LOUDNESS) on and off. The display area
of the decoder always shows the current
status briefly in text form; the
the display window is the permanent indi-
cator that loudness is switched on.
Select button in the decoder's menu con-
trol system
Change button in the decoder's menu
control system
Confirmation button in the decoder's
menu control system
Call up menu function
Brief press:
'Main menu'
Long press:
'Device Setup'
,
(F1)
symbol in
Advertisement
Table of Contents
