System Configuration - T+A DD 1230 R Operating Instructions Manual

In the 'Device Setup' you can adjust the settings for all
the audio and video components of your surround sys-
tem so that they match each other perfectly, and at the
same time set them to suit the acoustic characteristics of
your listening room.
Summary of 'Device setup'
Open Device Setup
(hold button pressed in)
F11/F12
Select buttons
F11/F12
/
Change buttons
F11/F12
/
Confirmation buttons
F11/F12

System Configuration

F1 Front panel
F1 Front panel
/ /
F1 Front panel
/ /
F1 Front panel
This procedure only needs to be carried out when you
are installing the system, or when you are adding or
replacing individual components of the system. The
following diagram shows the menu structure.
The table on the left shows how the menu system can be
controlled using the remote control buttons or the buttons
on the front panel of the decoder.
• The select buttons are used to move to pre-set posi-
tions where you can enter information.
• The change buttons alter the value at the input posi-
tion.
• If there is a further menu name at the data input posi-
tion, then pressing the confirmation button calls up
the corresponding sub-menu. Otherwise the confirma-
tion button closes the menu.
All menus are displayed page by page on the screen of a
television set (if connected), and at the same time line by
line on the decoder's integral screen.
The following section describes the menu points and
explains the adjustment facilities and their effects.
12