Connecting A Set-Top Box (Digital Sound And Picture Source) - T+A DD 1230 R Operating Instructions Manual

CD player or CD mechanism:
Connect the components as shown in wiring diagram 4
as follows:
• Connect the digital sound output of the CD mecha-
nism to the digital input (DIGITAL INPUT 2) of the
decoder using a co-axial digital lead.
• Connect the R socket on the CD player to the
LINK
R socket on the decoder; if this is already in use
LINK
by another source device, connect it to the vacant
R socket on the second source device.
LINK
Wiring diagram 4
A CD mechanism connected to the DD 1230 R.
A CD mechanism connected to the DD 1530 R.
37
•
If you also wish to use the CD player as a high-quality
analogue stereo source, connect its analogue output
to a vacant input on the pre-amplifier and assign the
source in the 'Source Setup'.
•
Finally connect the mains power supply and switch
the system on.
Note:
The purpose of connecting a CD player or CD mecha-
nism to the digital surround decoder is to play surround-
encoded CDs, or to exploit the artificial sound fields
available in the decoder. CDs encoded with Dolby Sur-
round and dts are available commercially.