Link - T+A DD 1230 R Operating Instructions Manual

Connecting the decoder to a
with TASI and R socket:

LINK

To keep the wiring diagram as clear as possible, only the
integrated amplifier is shown, i.e. not the analogue
source devices. The source devices should be con-
nected as shown in wiring diagrams 6 . . 11. Complete
the wiring of the components as shown in wiring diagram
2 as follows:
•
Connect the TASI interface on the decoder to the
TASI socket on the
amplifier using the TASI lead.
• Connect the R socket on the decoder to the
LINK
R socket on the integrated amplifier.
LINK
Connecting the DD 1230 R to a
integrated amplifier
pre-amplifier or integrated
Wiring diagram 2
integrated amplifier with TASI and R
• If your system includes an active subwoofer, connect
the pre-amplifier output PRE to the subwoofer input
SUB IN on the decoder.
Note:
If you are using a pre-amplifier with only one PRE
output, and you have already connected the power
amplifier to this, you can use a Cinch Y-lead adaptor
to gain access to the pre-amplifier signal. Please ask
your specialist
•
Finally connect the mains power supply and switch
the system on.
34
dealer for advice.
sockets.
LINK