Introduction
In general terms the function of the buttons on the remote control handset is the same as the corresponding buttons on
the machine's front panel.
The following table shows the remote control buttons and their function when operating the machine.
The buttons not required to operate the PA 2500 R are not shown in the illustration of the SRC1.
40
Remote control
Switches the device on and off
This button cyclically switches through the sources IN 1 to IN 7. If
necessary, press the button repeatedly until the desired
source is shown in the display. After the desired source has been
selected, the device switches to this input with a short delay.
A brief press switches the loudspeakers on in turn:
A B A+B
A long press switches the loudspeaker outputs off. A brief press
on the button switches the loudspeakers on again.
Increase / decrease volume
The volume can be increased / decreased in steps by tipping
one of the volume buttons. The current volume level is displayed
on the display screen. If one of the buttons is kept pressed for
approx.
2
seconds
continuously until the button is released.
Navigation
Returns to the previous point / change button
Confirms the input / change button
Selects the previous point within a list / select button
Selects the next point within a list / select button
Confirmation button during input procedures
Alpha-numeric input
Special characters are assigned to the and
buttons.
During the text input process it is possible to switch between
abc
numerical and alpha-numeric input, and between capital and
...
lower-case letters, using the button.
wxyz
During character input:
Switches between numeric and alpha-numeric input, and
between capitals and lower case when pressed (repeatedly)
Opens the configuration menu
(for detail see chapter entitled 'Basic settings of the
PA 2500 HV')
Opens the tone control settings menu
the volume increases /
decreases