Remote Control (Optional) - T+A E-SERIES PA 1000 E User Manual

28

Remote control (optional)

Introduction
In general terms the function of the buttons on the remote control handset is the
same as the corresponding buttons on the machine's front panel.
The following table shows the remote control buttons and their function when
operating the machine.

If a MP 1000 E is present in your system, the PA 1000 E can be controlled using
the FM1000 remote control of the MP 1000 E via the E2
In this case the optionally available FM2000 is not needed!
Except the source selection, the functions of the buttons described below are
the same for the FM1000.
With the FM1000 the desired listening source at the PA 1000 E can be selected

by pressing the
the desired listening source is selected.

Switches the device on and off

A brief press switches the loudspeakers on and off (MUTING)
Direct source select buttons

The listening sources can be selected directly using the
SOURCE buttons  to.
...
The LED`s above the source buttons on the front panel

indicate which input is currently selected for listening.
Decrease / increase the volume level

A brief press performs a small volume step first to enable a fine

and precise volume control. It automatically switches to a
continuous rotation of the volume control if the remote control
button is pressed for a longer time.

brief press: Switches LOUDNESS on and off
long press:
function)
button. If necessary press the button repeatedly until
Switches tone control on and off (FLAT-
control interface.
LINK