Table of Contents
Advertisement
DVD player as digital sound and picture source
Connect the components as shown in wiring diagram 3
as follows:
•
Connect the digital SURROUND sound output of the
DVD player to the digital input (DIGITAL INPUT 1) of
the decoder using a co-axial digital cable.
Note:
- Set the digital output of your DVD player to sur-
round mode!
- If the digital output of your DVD player is set to
'PCM', the player will only produce a digital stereo
signal. In this case the decoder cannot carry out
surround decoding.
•
If you also wish to use the DVD player as a high-
quality CD player, connect its analogue output to the
pre-amplifier input CD or AUX 1, and assign the
source in the 'Source Setup'.
•
•
•
Wiring diagram 3
A DVD player connected to the DD 1230 R.
A DVD player connected to the DD 1530 R.
36
Connect the AV-OUT socket of your DVD player to
the DVD socket on the decoder using a SCART lead.
Note:
If your DVD player does not feature a SCART socket,
use the VIDEO (Cinch) or S-VIDEO (Hosiden) and
AUDIO (Cinch) sockets on the decoder and the DVD
player.
Connect the R
socket on the DVD player to the
LINK
R
socket on the decoder; if this is already in use
LINK
by another source device, connect the lead to the va-
cant R
socket on the second source device.
LINK
Finally connect the mains power supply and switch
the system on.
Advertisement
Table of Contents
