Remote Control Handset - T+A A 1560 User Manual

Remote control units are available as optional extras for
all  units. The handset can be used to control
individual Hi-Fi system components.
The power amplifier can be remote-controlled in
conjunction with a pre-amplifier or reciever of the 'R'
series.
Please refer to the operating instructions supplied with
the Master unit of your 'R' series for details of how to use
the remote control unit.
The remote control unit F1 has to be switched to Hi-Fi
control. Move the   rocker to 'HiFi' position.
 
   
   
or
This button switches on or off the loudspeaker outputs
    A or     B individually.
   
(Only remote control handset F1)
This button switches off the loudspeaker outputs     A or
    B simultaneously.
 
 
The complete 'R'-system is switched to standby state by
pressing this button. Pressing this button a second time
switches all units on again. Standby state is indicated by
the green LED at the front panel of the 'R'-system master
respectively at the front of the 'R' pre-amplifier or receiver
which will still be still glowing.

Remote control handset

HiFi TV VCR
/ OFF A B
F1


F6
DISP A / B
A
Switching R units to Standby state:
' '
Keep the button pressed in until all units have switched to
Standby state. The pre-amplifier resp. receicer is the last
unit to switch off; this takes about four seconds.
Switching on R units:
' '
A brief press on the button (approx. 1 second) is enough
to switch all units on. However, be sure to hold the button
pressed in until the power amplifier switches itself on. If
the power amplifier does not switch on, press the button
again for about one second.
Note:
If the power amplifier was switched off by pressing the
 button at the front panel, you can only switch the   
amplifier on by pressing the same button again; the
remote control button unit is inefficacious in this situation.
24
F12
B