Change The Default Username And Password - CyberData 010878 Operation Manual

Web Page Item
On this page:
1. Specify whether you use Static or DHCP IP Addressing by marking the appropriate radio
button. Then, if you select Static, go to
Note
2. For Static IP Addressing, also enter values for the following parameters:
Note
3. Click Save Settings when you finish.

2.4.4 Change the Default Username and Password

On the Home page, click Admin Settings to open the Administator Settings page. After changing
the Username and Password on this page, new browser requests will require you to log in using
these new parameters.
VoIP Paging Server Operations Guide
Changing the IP Addressing selection causes the system to reboot when click Save Settings.
a. The Paging Server's IP Address: The Paging Server is delivered with a factory default IP
address. Change the default address to the correct IP address for your system.
Changing the Paging Server's IP Address causes the system to reboot when you click Save
Settings.
b. The Subnet Mask.
c. The Default Gateway.
Table 2-2. Network Setup Parameters
Description
Link to the PGROUPS Setup web page.
Link to the Upgrade Firmware web page.
Link to the Home page.
Step 2.
930132F
Implementing the VoIP Paging Server
Configuring the Paging Server
CyberData Corporation
12