Configure The Network Parameters - CyberData 010878 Operation Manual

Web Page Item
At this point you can:
Review the Paging Server's Current Settings. Use the RTFM switch to restore the factory
●
default settings. See
Configure the network parameters. Click Network Setup and refer to
●
the Network Parameters"
Configure the Admin parameters. Click Admin Settings and refer to
●
Default Username and Password"
Configure the SIP parameters. Click SIP Setup and see
●
Parameters".
Configure the PGROUPS parameters. Click PGROUPS Setup and refer to ....for instructions.
●
Note

2.4.3 Configure the Network Parameters

Configuring the network parameters enables your network to recognize the Paging Server and
communicate with it. Click Network Setup on the Home page to open the Network Configuration
page.
VoIP Paging Server Operations Guide
Table 2-1. Home Page Overview
Section 2.3.4, "Restore the Factory Default Settings as
for instructions.
Click the Upgrade Firmware button any time you need to upload new versions of the
firmware or Reboot the Paging Server. Refer to
Section 2.8, "Rebooting the Paging Server"
930132F
Description
Link to the SIP Setup web page.
Link to the PGroups Setup web page.
Link to the Upgrade Firmware web page.
for instructions.
Section 2.4.5, "Configure the SiP
Section 2.7, "Upgrading the Firmware"
for instructions.
Implementing the VoIP Paging Server
Configuring the Paging Server
Required".
Section 2.4.3, "Configure
Section 2.4.4, "Change the
CyberData Corporation
10
and