Order no. 14.20.93.4
Order no. 70.77.18.3
Order no. 70.77.02.7
Version 2.0
Accessories
6
Accessories
WARNING
ProMinent
®
metering pumps may not be assembled with
foreign parts which have not been tested and recommended
by ProMinent. Failure to observe this may result in personal
injury and damage to property for which no liability is
accepted!
6.1
Float switch
Two-stage with 2 m connection cable
6.2
Control cables
4-wire, 2 m, universal control cable
2-wire, 2 m, remote contact cable
6.3
Foot valves
With suction filter and ball check valve for connection at the end of the
suction line.
6.4
Injection valves
With spring-loaded ball check valve for metering into open or closed systems
and for fastening the discharge line; assembly direct to the liquid end.
6.5
Injection lances
For metering into large pipe cross sections and for preventing blockages
for media which effloresce.
6.6
Back-pressure valves
For accurate metering at low counter pressure or as relief safety valve.
6.7
Accumulators
For pulsation dampening e.g. for long discharge lines.
6.8
Metering monitors
For monitoring the metering. After eight non acknowledged metering strokes
an error message is displayed and the metering pump is switched off.
6.9
Suction lances
With foot valve and float switch for disposable drums or supply tanks.
6.10
Supply tanks
From 35 to 1000 l content with lockable screw cap and necessary
accessories.
6.11
Manual/electric stirrers
For mixing and preparing metering solutions.
6.12
Console
For stable mounting of the pump.
®
6.13
ProMinent
"Remote Control"
Type G4Ra consisting of gamma/4 metering pump and remote control
part. With this the metering pump can be controlled and operated from up
to 100 m via the remote control part.
Page 19 of 88 pages