Table of Contents
Advertisement
SmartLi 1.0
User Manual
Figure 8-13 Opening the valve
Step 12 Interconnect the dry contact cable of the fire extinguisher cylinder and the cable
reserved on the side of the cabinet.
Step 13 Check the end pressure gauge on the front of the cabinet. The pointer should be
in the green zone and the pressure reading should be greater than 1.6 Mpa at
20°C. Record the reading of the pressure gauge. 8 hours later, observe the pressure
gauge again. The pressure reading should remain unchanged.
Step 14 Reinstall the battery modules, baffle panels, copper bars, cables, front panel, and
fuse box in sequence.
Step 15 Reinstall the battery control unit.
Step 16 Press and hold the POWER ON/OFF button on the battery control unit for more
than 2s. The green indicator of the battery control unit blinks at 4 Hz.
Step 17 After the green indicator of the battery control unit blinks at 10 Hz, switch on the
battery circuit breaker on the SmartLi.
----End
Issue 08 (2022-11-15)
Copyright © Huawei Digital Power Technologies Co., Ltd.
8 Parts Replacement
103
Advertisement
Table of Contents
