AUMA SA 07.2 Operation Manual page 79

SA 07.2 SA 16.2 / SAR 07.2
AC 01.2 Non-Intrusive DeviceNet
SAR 16.2 Control unit: electronic (MWG)
1. Pull off indicator disc using a spanner as lever if required.
2. Refer to table and check if turns/stroke of the actuator correspond to the setting
of the reduction gearing (stages 1 9).
If the setting is not correct: continue with step 3.
If the setting is correct: continue with step 6.
Table 31:
MS5.2 control unit (1 to 500 turns per stroke)
Turns/stroke above to
1.0 1.9
1.9 3.9
3.9 7.8
7.8 15.6
15.6 31.5
31.5 62.5
62.5 125
125 250
250 500
Table 32:
MS50.2 control unit (10 to 5,000 turns per stroke)
Turns/stroke above to
10.0 19.5
19.5 39.0
39.0 78.0
78 156
156 315
315 625
625 1,250
1,250 2,500
2,500 5,000
3. Loosen screw [1].
4. Set crown wheel [2] to desired stage according to table.
5. Tighten screw [1].
6. Place indicator disc on shaft.
7. Set mechanical position indicator.
Commissioning (settings/options in the actuator)
Gear stage
1
2
3
4
5
6
7
8
9
Gear stage
1
2
3
4
5
6
7
8
9
79