Lenovo ThinkSystem SR665 V3 User Manual page 99

Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the M.2 backplane.
Figure 47. Installing the M.2 backplane on the air baffle
a. Align the guide holes on the M.2 backplane with the guide pins on the air baffle, and insert
the backplane into the air baffle.
b. Slide and hold the retention clip on the air baffle.
c. Rotate the M.2 backplane downward into place.
d. Release the retention clip. The retention clip will engage automatically.
e. Fasten the screw to secure the M.2 backplane.
Step 3. Connect the M.2 cables.
Figure 48. Connecting M.2 cables to M.2 backplane
a. Connect the M.2 cables to the M.2 backplane.
b. Tighten the screw on the signal cable.
Step 4. Install the M.2 drive on the M.2 backplane. See
After you finish
"Install an M.2 drive" on page
.
Chapter 5 Hardware replacement procedures
84.
89