Figure 38. Rotating the fan cage
Step 3.
Remove the intrusion switch assembly from the fan cage.
Figure 39. Removing the intrusion switch
a.
Move the intrusion switch connector in the shown direction to disengage it from the
keyhole.
b.
Release the intrusion switch cable from the pre-cut slots on the foam and fan cage bottom.
c.
Release the intrusion switch cable from the cable clip.
d.
Slide and pull the intrusion switch to remove it from the holder.
After you finish
1. Install a new intrusion switch. See
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
"Install the intrusion switch" on page
82.
.
Chapter 5
Hardware replacement procedures
81