Install A Hot-Swap Drive - Lenovo ThinkSystem SR665 V3 User Manual

Step 2. Slide the release latch to unlock the drive handle.
2.5-inch hot-swap drive
Step 3. Grasp the handle and slide the drive out of the drive bay.
2.5-inch hot-swap drive
After you finish
1. Install a new drive or drive filler to cover the drive bay. See
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Install a hot-swap drive

Follow instructions in this section to install a hot-swap drive.
About this task
Attention:
• Read "Installation Guidelines" on page 39
work safely.
• To make sure that there is adequate system cooling, do not operate the server for more than two minutes
without either a drive or a drive bay filler installed in each bay.
ThinkSystem SR665 V3 User Guide
78
3.5-inch hot-swap drive
3.5-inch hot-swap drive
"Install a hot-swap drive" on page
and "Safety inspection checklist" on page 40
78.
to ensure that you