Lenovo ThinkSystem SR665 V3 User Manual page 82

• Go to "Update the firmware" on page 189
Watch the procedure
A video of this procedure is available at YouTube:
DR4X1YAcp9wFKhwj_tLQ5Y
Procedure
Step 1. Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2. Install the 3.5-inch drive backplane.
Figure 34. Installing the 3.5-inch drive backplane
a. Align the backplane with the chassis and lower it into the chassis. Then, put the backplane
into place with it leaning backward slightly.
b. Rotate the backplane to vertical position to ensure that the four hooks on the chassis pass
through the corresponding holes in the backplane. Then, slide the new backplane as shown
until it is secured into place.
Step 3. Connect the cables to the drive backplane. See
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See
2. Reinstall the fan cage. See
3. Reinstall the air baffle if you have removed it. See
ThinkSystem SR665 V3 User Guide
72
for more information on firmware updating tools.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Install the system fan cage" on page
"Install the air baffle" on page
Chapter 6 "Internal cable routing" on page
"Install a hot-swap drive" on page
160.
167.
78.
59.