Operations; Activating/Deactivating Auxiliary Outputs; Paging Operation; Rebooting The Communications Module - Talk-a-Phone WEBS-PA-1 Configuration And Operation Manual

Operations

7 Operations
The Communications Module takes approximately one minute to boot.
The Communications Module needs to be programmed in accordance with the instructions provided
in Chapter 4 (Refer to 4 Using the Web GUI).

7.1 Activating/Deactivating Auxiliary Outputs

To provide additional visible or audible alerts upon an event, the Communications Module is equipped
with three Auxiliary Outputs. The Auxiliary Outputs can be used to connect devices such as a relay,
siren, a strobe light, and a PTZ camera. These devices can then be activated during an active mass
notification/page.

7.2 Paging Operation

®
The Communications Module can receive one-way paging messages from the WEBS Contact
Server and output the paging through the line level output. The Communications Module must be
®
registered with the WEBS Contact Server in order to receive incoming pages.

7.3 Rebooting the Communications Module

The WEBS-PA-1 can be rebooted using the Reset button (Refer to 2.1.2
36 Talk-A-Phone Co.