Table of Contents
Advertisement
Getting Started
5
On the Network Menu, click IP Settings.
To setup the WEBS-PA-1 for a Static IP (Manual Configuration), select the Static IP/Manual
(Refer to 4.4.1 IP Settings) option, and change the IP Address, Subnet Mask, and Gateway
according to the network where the WEBS-PA-1 is being deployed. Press Apply to save the
settings.
To setup the WEBS-PA-1 for DHCP (Automatic Configuration), select the DHCP option, for the
DHCP server on the network to provide a dynamic IP address. Press Apply and Reboot the
device to get an IP address from the DHCP server.
6
Disconnect the Ethernet cable from the PC and plug it to the required network port.
7
Access the WEBS-PA-1 Web Interface using the newly assigned
Configuration Using the Serial Console
1
Connect a null modem serial cable (DB9 Male to DB9 Female) from the serial port on the WEBS-
PA-1 to the COM port on the PC determined above in step 1-ii.
2
Open your preferred serial console application (e.g., HyperTerminal or TeraTerm) on the PC and
specify the following settings:
•
Baud rate (bits per second):
•
Data bits:
•
Parity:
•
Stop bits:
•
Flow control:
3
Create ipsettings.txt file using vi ipsettings.txt and configure the IP settings as per your network.
The below settings are meant for static configuration, for DHCP settings use NetworkMode = 1
4
Save the file (switch to command mode and use: wq followed by enter)
5
Run the configuration application to update the Communications Module IP configuration as
follows:
configApp admin admin@123 ipsettings.txt
For other configuration options, refer to Chapter 4 Using the Web GUI and Chapter 5 Using the
Serial Port.
3
It is recommended to change the password and make note of it after the installation.
4
In case of DHCP, determine the new IP address using ifconfig command on serial console or ask your DHCP server
administrator.
14
115200 bps
8
None
1
None
4
IP address.
Talk-A-Phone Co.
Advertisement
Table of Contents
