Table of Contents
Advertisement
3 Getting Started
The following are prerequisites for configuring the WEBS-PA-1 Communications Module.
1
PC must have the following specifications. The PC does not need to be connected to the
Communications Module permanently. All configuration and monitoring functions can be done
remotely via the network.
i.
Mozilla Firefox 3.5, 3.6, 4 or 5, Internet Explorer 8 or 9.
ii.
COM port, if using the serial console for programming. The available COM port number
will need to be known (e.g., COM1, COM2).
2
Power over Ethernet (PoE) or optional 12/24V DC power supply to power up the Communications
Module.
NOTE: Dedicated line regulated power supply required.
3
Provide the WEBS-PA-1 with a proper Ethernet network connection.
4
Decide whether the Communications Module should be configured for DHCP or static IP address
(network dependent). If the network requires static IP addresses, an available static IP address
should be assigned by the Network Administrator.
Power up the WEBS-PA-1 by connecting a 12V DC or 24V AC/DC power supply to the Power Supply
Input (Refer to 1.5 Related Documents: WEBS-PA-1 Quick Installation Guide, version 1.0
or by connecting to a PoE Layer 2 switch by connecting via the Primary Ethernet Port (WAN).
NOTE: If not using PoE, a dedicated line regulated power supply is required.
Configuration Using the Web GUI
1
Connect the Ethernet Cable to the Primary Ethernet port on the phone. By default, the WEBS-PA-
1 is pre-configured with a default static IP address of 192.168.1.10. Note that you must select the
appropriate Ethernet cable
being connected.
2
Change the IP address of the connected PC to be on the same subnet as the default IP address
of the WEBS-PA-1 (e.g., 192.168.1.3).
3
Open the Web browser and connect to the URL http://192.168.1.10.The browser prompts for
authentication
2
.
4
Enter the default Username as admin; and default Password as admin@123
authentication is successful, you are redirected to the Home page.
1
In general crossover cable is used to connect similar devices (computer to computer).
2
In case you are not prompted for authentication, Refer to Appendix B: Troubleshooting and Maintenance
13
1
(straight or crossover) depending on the peer device to which it is
3
. After
Talk-A-Phone Co.
Advertisement
Table of Contents
