Operator - KEB COMBIVERT S4 Instruction Manual

10. Accessories
10.4

Operator

E 42
As an accessory to the local operation an operator is necessary. To prevent
malfunctions, the Servo Controller must be brought into nOP status before
connecting/disconnecting the operator (open control release terminal X2.1).
When starting the Servo controller whitout an operator, it is started with the last
stored values or factory setting. The operator is obtainable in different versions:
Digital-Operator Digital-Operator Digital-Operator Digital-Operator Digital-Operator
Part.-No. 00.F4.010-2009 Part.-No. 00.F4.010-2009 Part.-No. 00.F4.010-2009 Part.-No. 00.F4.010-2009 Part.-No. 00.F4.010-2009
Interface control
Transmit "LED flickers"
Interface-Operator Interface-Operator Interface-Operator
Interface-Operator Interface-Operator
Part.-No. 00.F4.010-1009 Part.-No. 00.F4.010-1009 Part.-No. 00.F4.010-1009 Part.-No. 00.F4.010-1009 Part.-No. 00.F4.010-1009
In the Interface operator there is an additionally isolated RS232/RS485-Interface
integrated. The RS232/485-parameterizing interface expands the KEB
COMBIVERT S4 for communication with data communications equipment.
Suitable wiring permits the physically isolated data transmission.
PE-Connection
Servo controller
Parameterizing interface
5 4 3 2 1
9 8 7 6
5-digit LED-Display
Double function keyboard
! Connection see page E 23 !
PIN No. RS485 Signal
Norm
1 – –
2 – TxD
3 – RxD
4 A' RxD-A
5 B' RxD-B
6 – VP
7 C/C' COM
8 A TxD-A
9 B TxD-B
Operating-/Error display
Normal "LED on"
Error "LED blinks"
RS232/RS485
Meaning
reserved
Transmit signal / RS232
Receive signal / RS232
Receive signal A / RS485
Receive signal B / RS485
Supply voltage
+5 V, I = 10 mA
max
Data reference potential
Transmit signal A / RS485
Transmit signal B / RS485