KEB COMBIVERT S4 Instruction Manual page 33

Behaviour at External Fault
Offset REF 1
8. Parameter Description
This parameter determines the
response of the drive to an external
fault.
Value Response of Drive
0 Error message: E.EF
! To restart eliminate the fault and make a Reset !
1 Status message: A.EF
attaining speed 0.
! To restart eliminate the fault and make a Reset !
2 Status message: A.EF
! To restart eliminate the fault and make a Reset !
3 Status message: A.EF
! Automatic restart when fault condition no longer exists !
4 Status message: A.EF
attaining speed 0.
! Automatic restart when fault condition no longer exists !
5 Status message: A.EF
! Automatic restart when fault condition no longer exists !
6 Status message: none
! Fault is ignored !
Permits the shifting of the setpoint-speed characteristic.
n
max
2) 1)
"forward"
3)
-10 V
+10 V
n
max
"reverse"
Examples:
Characteristic 1: CP.16 = 0% (standard setting)
0V = 0 U/min
Rotation "forward": n is attained at +10V
max
Rotation "reverse": n is attained at -10 V
max
Characteristic 2: CP.16 = +40%
0V = 40 % of n "forward"
max
Rotation "forward": n is attained at 60% of +10V
max
Rotation "reverse": maximal 60% of n
Characteristic 3: CP.16 = –70%
0V = 70 % of n "reverse"
max
Rotation "forward": maximal 30% of n
Rotation "reverse": n is attained at 30% of -10V
max
Setting range:
Resolution:
Factory setting:
Remarks:
Customer setting:
→
Immediate disconnection of inverter!
→ →
Fast stop Disconnection of inverter after
→ →
Fast stop Holding torque at speed 0.
→
Immediate disconnection of inverter.
→ →
Fast stop Disconnection of inverter after
→ →
Fast stop Holding torque at speed 0.
→
No effect on the drive.
Adjustment of parameter
CP.7 and CP.8 must be
observed!
Setting range:
Resolution:
Faxtory setting:
Customer setting:
possible
max
possible
max
ANTRIEBSTECHNIK
0...6
1
0
ENTER-Parameter
-100...+100 %
0,1 %
0 %
%
E 33