2. Installation Preparation
2.1
Support Materials
In addition to industry standard tools, you will need the materials described in Table 2-1
during the installation.
Item
Ethernet
cable
Ground
cable
Pole
Distribution
box
2.2
Installation Tools
The following tools are needed during the installation.
Level bar
Table 2-1 Support Materials
Figure
Outdoor CAT6e,
yards)
It is suggested that the diameter of the cable is
greater than 7mm.
If the length of lead is more than 10 meters,
10mm² diameter grounding cable should be used.
If the length of lead is less than 10 meters, 10mm²
diameter grounding cable should be used.
The diameter of the pole is between 40mm and
70mm. It is suggested that the pole is made of
hot-galvanized steel.
Channel steel and equal angle steel installation are
also supported. The width of the channel steel is
50mm to 100mm; the length of side of the angle
steel is 63mm to 80mm.
PoE adaptor, power grounding point, broadband
access is all in the distribution box, which must be
waterproofed.
Marking pen
Description
shorter than 100 meters (~109
Knife
Vise
7
Wrench