2.
Assemble the pole mount part and fix it on the pole. Note that the height must satisfy
the requirement described above.
The screw hole a is used to assemble and fix the two components of the bracket,
and the screw hole b is used to adjust the angle of the eNB, which helps the eNB to
receive signals better.
3.
Align screws holes on the back bracket with corresponding screw holes on the pole
mount bracket. a corresponds to a, and b corresponds to b. First, screw at position a
to mount the eNB on the pole mounting bracket. Note that do not fasten the screws.
And then adjust the angle of the eNB and fasten screws at position b. At last, fasten
screws at position a.
11