Table of Contents
Advertisement
ATTENTION: If the diameter of the Ethernet cable is less than 7mm, the connector
cannot be locked. The eNB will be flooded and damaged.
1.
Unscrew the ETH connector in sequence.
2.
Pass through the Ethernet cable the unscrewed connector based on original
sequence.
3.
Insert the RJ-45 connector to the ETH/POE port at the right bottom of the eNB.
4.
Tighten the connector of the ETH/POE port in sequence.
5.
Connect the other end of the Ethernet cable to the POE port of the PoE adaptor.
6.
Connect the LAN port of the PoE adaptor to a LAN switch or a router for
maintenance and backhaul.
NOTE: The PoE adaptor must have lightning protection measures and be placed in a waterproof
position.
Connect the PoE adaptor to an AC power.
7.
15
Advertisement
Table of Contents
