Table of Contents
Advertisement
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. If one or more NVMe solid-state drives are to be removed, disable them beforehand in the operating
system (see the documentation for your operating system for information and instructions). See the
labels on the drive to determine the type of the drive to remove.
To remove a 2.5-inch drive, complete the following steps:
Step 1.
Gently rotate the release latch away to unlock the drive handle.
Figure 44. Drive removal
Step 2.
Grasp the handle and pull the drive out of the drive bay.
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install a 2.5-inch hot-swap drive
Use this procedure to install a 2.5-inch drive.
Following are the types of drives supported by this server:
• NVMe solid-state drive
• SATA/SAS solid-state drive
• SATA/SAS hard-disk drive
For a complete list of supported optional device for this server, see
serverproven/index.shtml
Before installing a 2.5-inch hot-swap drive:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install a 2.5-inch drive, complete the following steps:
Step 1.
If new drives are to be added, see "Install a 2.5-inch drive" in ThinkSystem SR850 Setup Guide to
determine available drive bays to the new drives.
ThinkSystem SR850 Maintenance Manual
60
55).
.
55).
"Safety" on page iii
and
https://static.lenovo.com/us/en/
"Safety" on page iii
and
"Installation
"Installation
Advertisement
Table of Contents
