TalkAnytime Quick Start Instructions
Connectivity Test
The procedures "Phone/IP Starter Configuration" and "Phonebook Starter Configuration" must be
completed before you can do this procedure.
1. The setup for testing connectivity is shown below.
After the settings shown here have been made in the TalkAnytime Configuration program, click on Save
Setup.
2. From a browser at the command PC, type in the test URL with "Digits=No."
If a connection is made and the phone connected to Channel 1 of the TalkAnytime unit rings, then
connectivity has been demonstrated.
If a connection cannot be made, skip to Troubleshooting below.
3. From a browser at the command PC, type in the test URL with "Digits=Yes." At the TalkAnytime client
Dial
software, click
If a connection is made and the phone connected to Channel 1 of the TalkAnytime unit rings, then
connectivity has been demonstrated.
If a connection cannot be made, skip to Troubleshooting below.
Multi-Tech Systems, Inc.
Setup for Connectivity Test
Ethernet
Ch1 (FXS)
Port
TalkAnytime
Ch2 (FXS)
TA-410/810
Settings:
IP Addr= 65.129.90.2
Voice/Fax Coder field: Automatic
Interface: FXS
Inbound Phonebook
Channel 1
Description field: test-xyz
.
TalkAnyTime User Guide
Ethernet
Hub
Command
PC
IP Addr= 65.129.90.3
URL://65.129.90.2/tat.cgi?
Service=test-xyz&
Protocol=TCP&
Codec=G723&
Digits=Yes
No
Connectivity Test
41