Table of Contents
Advertisement
URL Configuration
Connectivity Test
The procedures "Phone/IP Starter Configuration" and "Phonebook Starter Configuration" must be
completed before you can do this procedure.
1. The setup for testing connectivity is shown below. The settings in the T1/E1 Parameters screen must be
made to fit your PBX and overall system.
After the settings shown here have been made in the TalkAnytime Configuration program, click on Save
Setup.
2. From a browser at the command PC, type in the test URL with "Digits=Yes." At the TalkAnytime client
software, click
Dial
extension on the TalkAnytime dial pad (on the screen). The phone at the designated PBX extension
should ring.
If a connection is made and the designated phone extension of the PBX rings, then connectivity has been
demonstrated.
If a connection cannot be made, skip to Troubleshooting below. Troubleshooting involves a ping test. If
you can ping the TA-2410/3010 successfully but cannot make a call, then there may be a problem with
your T1/E1 Parameters settings. Check those settings and re-test.
If a connection cannot be made, skip to Troubleshooting below.
3. The LEDs on the front panel of the TalkAnytime unit will also help you confirm connectivity. If the TA-
2410/3010 is configured correctly and connected properly, the ONL LED should be on, and the LC and
LS LEDs should be off.
Setup for Connectivity Test
T1/E1
Connection
Digital Voice
Trunk Port
PBX
Settings:
IP Addr= 65.129.90.2
Voice/Fax Coder field: Automatic
T1/E1 Params: per system needs
Inbound Phonebook
Channel 1
Description field: test-xyz
. You will then hear a dial tone coming back from the PBX. Enter the designated PBX
TalkAnytime Quick Start Instructions
Ethernet
Hub
Command
Ethernet
Port
TalkAnytime
TA2410 or
TA3010
IP Addr= 65.129.90.3
URL://65.129.90.2/tat.cgi?
Service=test-xyz&
Protocol=TCP&
Codec=G723&
Digits=Yes
46
PC
Advertisement
Table of Contents
