Table of Contents
Advertisement
TalkAnytime Quick Start Instructions
Install TalkAnytime Configuration Software onto Command PC
For more details, see Chapter 4: Software Installation in User Guide.
1. TalkAnytime unit must be properly cabled. Power must be turned on.
2. Insert TalkAnytime CD into drive. Allow 10-20 seconds for Autorun to start. If Autorun fails, go to
My Computer | CD ROM drive | Open. Click Autorun icon.
3. At first dialog box, click Install Software.
4. At 'welcome' screen, click Next.
5. Follow on-screen instructions. Accept default program folder location and click Next.
6. Accept default icon folder location. Click Next. Files will be copied.
7. Select available COM port on command/control computer.
8. At completion screen, click Finish.
9. At the prompt "Do you want to run TalkAnytime Configuration?," click No. Software installation is
complete.
Phone/IP Starter Configuration
Full details here: Technical Configuration chapter in User Guide
1. Open the TalkAnytime program:
Start | TalkAnytime xxx | Configuration.
2. Go to Configuration | Ethernet/IP. Enter the IP parameters for your TalkAnytime unit. Activate Packet
Prioritization (802.1p) if desired. For details, see the "Technical Configuration" chapter of the User Guide.
3. Do you want to configure and operate the TalkAnytime unit using the web browser GUI? (It has the
same functionality as the local Windows GUI, but offers remote access.)
If NO, skip to step 5. If YES, continue with step 4.
4. Web Browser GUI Setup (Optional). To do configuration and operation procedures using the web
browser GUI, you must first set it up. To do so, follow these steps. (The browser used must be Internet
Explorer 6.0 or above; or Netscape 6.0 or above; or FireFox 1.0 or above.)
A. Be sure an IP address has been
assigned to the TalkAnytime unit
(this must be done in the
TalkAnytime Windows GUI).
B. Save Setup in Windows GUI.
C. Close the TalkAnytime Windows
GUI.
D. Install Java program from
TalkAnytime product CD.
(Must be Java Runtime
Environment 1.4.2_01 or above.)
NOTE: Required on first use of
Web Browser GUI only.
Need more
info?
Multi-Tech Systems, Inc.
E. Open web browser.
(Note: The PC being used must
be connected to and have an IP
address on the same IP network
that the TalkAnytime is on.)
F. Browse to IP address of
TalkAnytime unit.
G. If username and password have
been established, enter them
when prompted by the
TalkAnytime.
H. Use web browser GUI to
configure or operate the
TalkAnytime unit.
See "Web Browser Interface" in Operation &
Maintenance chapter of
User Guide
TalkAnyTime User Guide
Configuration Software Installation
(on CD).
22
Advertisement
Table of Contents
