Advertisement
FOR REFERENCES ONLY
Standard setting mode
4
For reasons of safety, the following parameters have been set up so that they cannot be reprogrammed while the
inverter is running.
［Basic parameters］
(Guidance function)
(Automatic acceleration/deceleration)
(Torque boost setting macro function)
*(Command mode selection)
［Extended parameters］
to
to
,
to
, , ,
* and can be changed during operation by setting =.
VFNC3C ENGLISH MANUAL
: The mode changes to the Standard setting mode when
the EASY key is pressed and "" is displayed.
Both basic and extended all parameters are displayed.
Basic parameters
: This parameter is a basic parameter for the
operation of the inverter.
Refer to chapter 5 for details.
Refer to chapter 11 for parameter tables.
Extended parameters : The parameters for detailed and special
setting.
Refer to chapter 6 for details.
Refer to chapter 11 for parameter tables.
D-4
NOT SUBJECTED FOR RESALE
*(Frequency setting mode selection)
(Maximum frequency)
(V/F control mode selection)
(Default setting)
to
,
to
, , ,
to
,
2
Advertisement
