Advertisement
FOR REFERENCES ONLY
6.20.5 Changing the initial display of the panel
: Initial panel display selection
: Initial remote keypad display selection
Function
This parameter specifies display format while power is ON.
Changing the display format while power is ON
When the power is ON, the standard monitor mode displays the operation frequency (default setting) in the
format of "" or "". This format can be changed to any other monitor display format by setting
. This new format, however, will not display an assigned prefix such as or . When the power is
ON, the display of the extension panel is set at .
When the power is ON, the main panel and the extension panel can be set to display differently.
[Parameter setting]
6
Title
For details on / =, see the Communications Function Instruction Manual.
6.20.6 Changing display of the status monitor
- : Status monitor 1 to 6
Change monitor display items in the status monitor mode.
Refer to chapter 8 for details.
6.20.7 Integrating wattmeter
f749 : Integrating wattmeter display unit selection
Function
At the main power off, this monitor value is cleared and also, the display unit is selectable.
Title
f749
Integrating wattmeter display unit selection
VFNC3C ENGLISH MANUAL
Function
0: Operation frequency (Hz/free unit)
Initial panel display selection
1: Output current (%/A)
2: Frequency setting value (Hz/free unit)
Initial remote keypad display
3 to 17: -
selection
18: Arbitrary code from communication
Function
F-66
NOT SUBJECTED FOR RESALE
Adjustment range
Default setting
Adjustment range
Default setting
0:1=1kWh
1:1=10kWh
2:1=100kWh
3:1=1000kWh
0
0
Depends on
the capacity
(Refer to
section 11.4)
Advertisement
