Multitech MultiFRAD FR221 User Manual page 34

MultiFRAD User Guide
43 Click DLCI and the Frame Relay DLCI Setup dialog box is displayed.
The Compression option may be useful at low link speeds (i.e., below 56K); however, do not use
this feature with a high speed link (i.e., 56K or higher). Click to enable this option for each DLCI on
which you want to use the compression function.
44 Click the DLCI you want to map. The Protocol Mappings, Port Mappings, and all the other groups
become active. To map the network protocol to the selected DLCI, click the down arrow for the active
protocol (Map IP Address, Map IPX Network Number, or Map STP WAN Number) and select the
IP address, IPX network number, or STP WAN number you want to use.
45 To map a data port to this DLCI, click (to enable) the Data Port (Data Port 1 or Data Port 2 in the Port
Mappings group) that you want to associate with this DLCI.
46 Click the Committed Information Rate text box in the Settings (in Bits/second) group and enter
the CIR value your service provider supplied for this DLCI.
47 Click the Excess Burst Rate (Be) text box in the Settings (in Bits/second) group and enter the Be
value your service provider supplied for this DLCI.
48 Ensure that Throttle Up and Down is selected in the Congestion Management group.
49 Ensure that Adhere to CIR + Be is selected in the Mode group. Multi-Tech recommends using this
setting initially.
50 Repeat steps 44 through 49 for each new DLCI.
51 Click OK when you are satisfied with all your selections.
52 The Frame Relay Setup dialog box is displayed.
34