Table of Contents
Advertisement
5
On the FR221/V2 only: if you are connecting your MultiFRAD to a station device; e.g., analog
telephone, fax machine, or Key Telephone System (KTS); connect one of the supplied RJ-11 cables
to the Voice/Fax Channel 1 FXS connector on the back of the MultiFRAD and the other end to the
station device.
If you are connecting your MultiFRAD to a PBX extension, connect one of the supplied RJ-11 cables
to the Voice/Fax Channel 1 FXO connector on the back of the MultiFRAD and the other end to the
PBX extension
If you are connecting your MultiFRAD to an E&M trunk from a telephone switch, connect one end of
an RJ-45 phone cord to the Voice/Fax Channel 1 E&M connector on the back of the MultiFRAD and
the other end to the trunk. Note: Appendix a has a pinout diagram for the E&M back panel connector
on the MultiFRAD.
6
Repeat the above step to connect the remaining telephone equipment to Voice/Fax Channel 2 on
your MultiFRAD.
7
Connect the power supply to a live AC outlet, then connect the power supply to the MultiFRAD as
shown in Figure 2-2. The Power connector is a 7-pin circular DIN connector.
At this time your MultiFRAD is completely cabled. Proceed to the section Loading Your Software to
install your software.
Chapter 2 - Installation
17
Advertisement
Table of Contents
