Multitech MultiFRAD FR221 User Manual page 31

31 Repeat the above step to configure the interface type for voice/fax channel 2. To change the channel
number, click the down arrow and highlight Channel 2.
32 When you are satisfied with your interface choices, and if the default voice coder is acceptable and
your country/region is the default USA, then you can click OK and continue building your phone
directory database.
If you need to change the voice coder, click the Voice/Fax tab and proceed to step 34.
If your country/region is not the default USA, then click on the Regional tab and proceed to step 35.
33 To change the voice coder, first select the channel by clicking the Select Channel down arrow and
highlighting the channel number, then click the Voice Coder down arrow and highlight your new voice
coder entry.
If you change the voice coder, ensure that the same voice coder is used on the voice/fax channel you
are calling; otherwise, you will always get a busy signal.
Note: After configuring a given channel (1, or 2), you can copy that channel's configuration to the
other channel by selecting the other channel in the "Duplicate To" group and clicking the Copy
button. Everything on the Voice/Fax tab will be copied to the other channel.
34 To change the Tone Pairs, click the Regional tab and then click the Country/Region down arrow
and highlight your specific country or region.
The Tone Pairs parameters change per your choice. Click OK when finished.
35 The Checking MultiFRAD dialog box will appear.
Chapter 3 - Software Loading and Configuration
31