A 3 Connecting Unshielded Cables - Phoenix Contact ILC 131 ETH Installing And Operating Information

ILC 1X1
98
PHOENIX CONTACT
A 3 Connecting unshielded cables
Unshielded cables are used to connect the I/O devices and the supply voltage to the Inline
controller.
Connect these cables to the relevant Inline connectors using the spring-cage connection
method. You may connect cables with a connection cross section of 0.2 mm
(24 - 16 AWG).
B
Figure A-1 Connecting unshielded cables
Wire the connectors according to your application.
When wiring, proceed as follows:
• Strip 8 mm off the cable.
Inline wiring is normally carried out without ferrules. However, it is possible to use ferrules.
If using ferrules, make sure they are properly crimped.
• Push a screwdriver into the actuation shaft of the appropriate terminal point (Figure A-1,
A) so that you can insert the wire into the spring opening.
Phoenix Contact recommends the SFZ 1-0,6x3,5 screwdriver (Order No. 1204517).
• Insert the wire (Figure A-1, B). Remove the screwdriver from the opening. This clamps
the wire.
After installation, the wires and the terminal points should be marked.
A
2 2
to 1.5 mm
8385_en_02