Activating/Deactivating The Http Server - Phoenix Contact ILC 131 ETH Installing And Operating Information

ILC 1X1
Deactivating
Activating
68
PHOENIX CONTACT
3.8.4

Activating/deactivating the HTTP server

This function is supported by Inline controllers from firmware version 4.20 or later and
from PC Worx version 6.30.767 or later (part of the AUTOMATIONWORX Software Suite
1.81 including AddOn V1).
To protect the Inline controller against unauthorized access, it may be necessary to deacti-
vate the HTTP server. To do this, proceed as follows:
• Switch to the bus configuration workspace in PC Worx.
• Select the controller, e.g., "ILC 151 ETH", in the "Bus Structure" window.
• Select the "Extended Settings" tab in the "Device Details" window.
• Select the "Web server" setting under "Extended Settings".
• Select the setting "Disabled" from the drop-down list.
• Click "Send" (hidden by the drop-down list in Figure 3-30) to transmit the setting to the
Inline controller.
• Restart the Inline controller.
Figure 3-30 Disabling HTTP
If you have selected the "Disabled" function, the HTTP server (web server) is deactivated.
HTTPS is also deactivated (refer to Section 3.8.5).
Proceed as follows to activate the HTTP server:
• Select the setting "HTTP (Port 80)" from the drop-down list.
• Click "Send" (hidden by the drop-down list in Figure 3-30) to transmit the setting to the
Inline controller.
• Restart the Inline controller.
8385_en_02