Tamarack Solar LTP HW Mount Series Installation Manual page 8

LTP HW Mount Series
Detail C:
B. To make the double rail assembly, lay four of the Cross Rails end to end and back to back, as shown
in Detail D. Make sure that the sides with the obround slots all face up. Place two rail connectors, one
on each side, in the open sides of the rails, centered on the seam between the two rail halves, and
with their flanges down, as shown in Detail D. Bolt the double rail assembly together using the 3/8”
16 x 1” hex bolts, flat washers, and flange nuts. Tighten all the bolts to 20 ft lbs (dry) and set this
assembly aside.
Detail D:
7