Step 11: Adjust Tilt Angle ……………………………………………………………………………………………………; Step 12: Install Lower Knee Brace .……………………………………………………………………………………&#X85 - Tamarack Solar LTP HW Mount Series Installation Manual

Step 11: Adjust Tilt Angle
A. Remove the lower two 1/2" 13 x 1.25” bolts from the Tilt Plates and tilt the array to the desired
angle. The array tilts in 10° increments from 0° to 60°. Re install the 1/2" 13 bolts and torque all six
bolts (three per Tilt Plate) to 40 ft lbs.
Step 12: Install Lower Knee Brace
A. Pre assemble the Lower Knee Brace Clamp body to the Angle Brackets with the 1/4”x 3/4” bolts, flat
washers and flange nuts, and torque to 84 in lbs. (see Detail S). Set aside the 5/16” 18 x 1” bolt, flat
washer and flange nut attached to one of the Angle Brackets.
B. Attach the Lower Knee Brace Clamp loosely to the pole with the 1/2" 13 x 6" U bolt, flat washers,
lock washers and nuts as shown in Detail T). Hand tighten just enough to keep it from sliding down
the pole. See previous Detail Q table for clamp location position on the pole
Detail S:
Detail T:
19
LTP HW Mount Series
.