Related Manuals for Tamarack Solar UNI-PGRM 2019 Series
Summary of Contents for Tamarack Solar UNI-PGRM 2019 Series
- Page 1 Horizontal Pole Mount Installation Manual UNI-PGRM 2019 Edition V3.1 For models: UNI-PGRM/01 UNI-PGRM/02 UNI-PGRM/03 UNI-PGRM/04 UNI-PGRM/05 UNI-PGRM/06...
-
Page 2: Table Of Contents
Customer Support Tamarack Solar makes every effort to ensure your m ounting kit is easy to install. If you need assistance at any point in your installation or have suggestions on how we can improve your experience, call customer support at 1-800-819-7236 or email us at sales@tamaracksolar.com... - Page 3 Horizontal Installation Manual Pole Mount Galvanized coated sheet steel components will show rust on cut edges. This is normal and will not affect the structure and function of the mount. UNI-PGRM-END (2per) ITEM PART NUMBER DESCRIPTION QTY. 51-0835-ECB REV B END CLAMP BASE 51-0835-UPC REV A UNDER PANEL FRAME CLAMP 51-0835-UBC rev B...
-
Page 4: Main Beam Length, Post Placement Calculations
Horizontal Installation Manual Pole Mount Main Beam length, Post Placement Calculations Step 1 : Measure Modules A. Compute Main Beam Length per the following formula W= Module Width Q= Quantity of Modules Beam Length formula 4.82 + (Q x W) + ((Q – 1) x 1.28) 6 Module Example at 39.5"... -
Page 5: Step 3: Install Modules
Horizontal Installation Manual Pole Mount Step 3: Install Modules A. Based on the main beam calculations, position and place an end clamp base onto the main beam pipe as shown below at one end. B. Place a level on the clamp to hold a horizontal position at this time. (Final angle adjustment will be done later) C. - Page 6 Horizontal Installation Manual Pole Mount Lay the first module onto the flat flanges of the end and mid clamp bases. Center the module to overhang equally past the clamps. Loosen the mid clamp, move to fit against the module and re tighten to hold position. Attach under module clamps to the module and end clamp base with the 5/16-18 x 7/8 bolt flange nut and washer as shown, torque to 12ft Lbs.
-
Page 7: Step 4: Set Final Angle
Horizontal Installation Manual Pole Mount Loosen the mid clamp, move to fit against the module and re tighten to hold position. Install mid clamp top with the 1/4 x 2.5 hex bolts, flat & lock washers and torque to 7ft Lbs. Repeat until last module is ready, then add the last end clamp base 1/4"... - Page 8 Horizontal Installation Manual Pole Mount...
-
Page 9: Installer Responsibility
Tamarack Solar by Purchaser, any employee of Purchaser, client of Purchaser, end-user of the Product or other party, even if Tamarack Solar has been advised of the possibility of such claims or demands (collectively, “Third Party Claims”). This limitation applies to all materials provided by Tamarack Solar during... -
Page 10: Foundation Hole Guidelines
Horizontal Installation Manual Pole Mount Foundation Hole Guidelines The suggestions below are recommendations only. It is the installer’s responsibility to validate foundation parameters prior to installation, as local geotechnical report may be required to assess ground conditions. We recommend consulting with a local engineer familiar with local regulations and build site requirements, including soil conditions, terrain and load criteria (wind, snow, seismic).