Step 7: Attach Tilt Plates; Step 8: Attach Cross Rails To Tilt Plates - Tamarack Solar LTP HW Mount Series Installation Manual

Step 7: Attach Tilt Plates

A. Attach Tilt Plates, with the flanges facing to the outside as shown in Detail J, using the six 1/2” 13 x
1.25” bolts (three for each Tilt Plate), flat washers, lock washers and nuts. Position the Tilt Plates
with the top level (0° tilt). Do not torque at this point, but tighten snuggly, only enough to hold the
Tilt Plates firmly for the next assembly steps.
Detail J:

Step 8: Attach Cross Rails to Tilt Plates.

A. Place the previously assembled doubled Cross Rail assembly across the north end of the Tilt Plates,
and one of the single rail Cross Rail assemblies across the south end of the Tilt Plates, with the open
side of the single rail assembly facing to the inside. Place so that both rail assemblies have the
obround slots facing up, as shown in Detail K. Center the two assemblies on the Pole Clamp, using
the seam between the two Cross Rail sections as the location of the center of the assembly. Attach
the two Cross Rail assemblies to the Tilt Plates using the 1/2" 13 x 1.25” bolts, flat washers, lock
washers, and nuts, in the six places shown in Detail K. Torque to 40 ft lbs.
13
LTP HW Mount Series