Tamarack Solar LTP HW Mount Series Installation Manual page 21

C. Loosely attach the Outer Swivel Brackets to the Lower Knee Brace Clamp with the (previously set
aside) 5/16” 18 x 1” bolt, flat washer, and flange nut, as shown in Detail U.
Note: The flanges on both brackets need to face to the outside as shown in Detail U.
Detail U:
D. Attach the two Outer Swivel Brackets to the lower flange of the Knee Brace Cross Rail, one on each
side, and 21” in from the ends of the Knee Brace Cross Rail, as shown in Detail R. using the 5/16” 18
x 7/8” bolts, flat washers, and flange nuts (two bolts per bracket). Flange nuts to be on the inside of
the Knee Brace Cross Rail. Tighten to 144 in lbs (dry).
E. Loosely attach the Inner Swivel Brackets to the Outer Swivel Brackets, as shown in Detail V, using
the 5/16” 18 X 3.5” bolts, flat washers, and flange nuts.
Detail V:
20
LTP HW Mount Series