Step 6: Attach Tilt Plate Mounting Channels - Tamarack Solar LTP HW Mount Series Installation Manual

Step 6: Attach Tilt Plate Mounting Channels

A. Place the two Tilt Plate Mounting Channels on the sides of the Pole Clamp assembly as shown in
Detail I. Also note the “helpful tip” in Detail I.
B. Install 1/4" bolts, flat washers, and flange nuts in the six mounting holes on each Tilt Plate
Mounting Channel (two on each side, and two on the top). Tighten to 84 in lbs.
Note: Placing the flange nut in the “closed” side of the wrench to align with the bolt through
the cutout will make it easier to start the nuts on the treads and help prevent dropping the nut
into the assembly where they cannot be easily retrieved. (see photo in Detail I).
Detail I:
12
LTP HW Mount
Helpful tip:
Pre install 1/2” bolt in these
holes on both channels for
ease of assembly in Step 7
Series