Troubleshooting - Brother GTX600NB Instruction Manual

8

Troubleshooting

Chapter8
CAUTION
Ensure there is adequate space left in front of the printer and avoid placing any objects. Otherwise your hand
may get caught between the platen and an object, which may result in injury.
Do not handle the platen while printing. If your hand gets caught between the platen or the T-shirt tray and
the covers, it may be injured.
Do not put your hands inside the covers while the printer's power is turned on. Otherwise your hands may
touch against moving parts and this may result in injury.
Be careful not to pinch your fingers when closing each door and cover. You may get injured if you pinch your
fingers.
When you mount or replace the head, be careful not to get your hands or fingers caught. Otherwise you may
be injured.
Do not drink liquids such as the ink, maintenance solution, cleaning solution, pretreatment, or waste. They
may cause diarrhea or vomiting.
When handling liquids, such as the ink, maintenance solution, cleaning solution, pretreatment, and waste ink,
use protective glasses and gloves to avoid causing your eyes and skin to contact the liquids. It may cause
inflammation. In case of contact with eyes, do not rub but immediately rinse the eyes with water.
Keep the liquids out of the reach of children.
Be sure to wear protective goggles and gloves when handling the grease, so that it does not get into your
eyes or onto your skin.
It can cause inflammation. Do not drink or eat the grease. It may cause diarrhea or vomiting.
Keep the liquids out of the reach of children.
When replacing parts and installing optional accessories, be sure to use only genuine Brother parts. Brother
will not be held responsible for any accidents or problems resulting from the use of non-genuine parts.
When replacing parts or installing optional accessories, be sure to follow the procedures described in the
Instruction Manual. Incorrect procedures could cause injuries or problems.
IMPORTANT
Do not move the platen by hand. Otherwise the printer may be mechanically and electrically damaged.
8-1