Led Reject Codes; Banknote - JCM GLOBAL iVIZION2 Series Integration Manual

Troubleshooting iVIZION™2 Series Banknote Validator Foundation of Intelligent Validation

LED Reject Codes; Banknote

Status LED
Banknote Insertion Error
Banknote is rejected by a
Green
skew detection
Flashes
(1)
UV Point Sensor Error
Green
A Banknote was rejected by
Flashes
the UV Point Sensor
(2)
Banknote remaining Error
(Validator)
A Banknote was rejected as
Green
the Validator detected a
Flashes
remaining Banknote left
(3)
inside
Reserved
Green
Flashes
(4)
Transport Time-Out Error
The timing of transporting a
Green
Banknote was not appropriate
Flashes
(5)
Denomination Error
A Banknote was rejected due
Green
to the denomination
Flashes
verification result
(6)
Reserved
Green
Flashes
(7)
Photo Level Error
A Banknote was rejected due
Green
to the transmissive level
Flashes
result
(8)
INHIBIT Error
A Banknote was rejected due
to the INHIBIT Settings
Green
(Banknote acceptance is
Flashes
inhibited).
(9)
No Command is returned to
Escrow
Reject Request
Green
The Host Machine requested
Flashes
for reject
(10)
Reserved
Green
Flashes
(11)
Reserved
Green
Flashes
(12)
P/N 960-000231R_Rev. A
Table 24 LED Reject Codes; Banknote
Error
•
Clean the relative Sensor(s) if they are
dirty or foreign objects are adhering to
them.
•
Calibrate the relative Sensor(s) as
needed.
•
Clean the relative Sensor(s) if they are
dirty or foreign objects are adhering to
them.
•
Calibrate the relative Sensor(s) as
needed.
•
Clean the relative Sensor(s) if they are
dirty or foreign objects are adhering to
them.
•
Calibrate the relative Sensor(s) as
needed.
•
Clean the relative Sensor(s) if they are
dirty or foreign objects are adhering to
them.
•
Calibrate the relative Sensor(s) as
needed.
•
Clean the relative Sensor(s) if they are
dirty or foreign objects are adhering to
them.
•
Calibrate the relative Sensor(s) as
needed.
•
Clean the relative Sensor(s) if they are
dirty or foreign objects are adhering to
them.
•
Calibrate the relative Sensor(s) as
needed.
•
Check that the INHIBIT settings on a
Host Machine or iVIZION2 DIP Switches
is appropriate.
•
Check that the INHIBIT settings on a
Host Machine is appropriate.
Solution
-
-
-
-
© 2022, JAPAN CASH MACHINE CO., LTD.
3 5
Section 8
Relative Part/Sensor
•
Sensors of the Validator
•
Sensors of the Validator
•
Sensors of the Validator
-
•
Sensors on the Transport
Path
•
Sensors of the Validator
-
•
Sensors of the Validator
•
INHIBIT Settings on the
Host Machine
•
INHIBIT Settings on the
iVIZION2 Unit
•
INHIBIT Settings on the
Host Machine
-
-