Placing Foreign Objects Into The Unit; Operation; Preventive Maintenance - JCM GLOBAL iVIZION2 Series Integration Manual

Section 1 iVIZION™2 Series Banknote Validator Foundation of Intelligent Validation
•
While transporting, do not apply
too much pressure to the unit, or
subject it to excess vibration.
•
Do not throw or apply excessive
force to the unit.
Disconnect Main Plug
From Electrical Outlet
Plugging or unplugging the communi-
cation connector while electrical
power is being applied to the Unit
may cause damage to the Unit.
Be sure to carry or transport the Unit
with the Cash Box installed. Exerting
external pressure on the equipment
without the Cash Box in place may
cause it to distort.

Placing Foreign Objects into the Unit

•
Do not insert anything except
Banknotes or Tickets into the Inser-
tion Slot. Inserting Receipts, Paper
Clips, Rubber Bands, Credit Cards,
etc. into the Unit may damage the
Banknote Transport path.
•
Do not inject water or liquid agents
of any kind into the Unit, as this
may cause extreme damage to the
Unit.

Operation

•
Do not drop or apply external pres-
sure on the Cash Box. The
Banknotes stacked up inside of the
Cash Box may collapse.
•
Do not manually refill the Cash Box
with the Banknotes.
Pinch Point Hazard
Be careful to avoid any personal
injury to fingers when closing any
part such as Transport Unit or Valida-
tion Unit.
When closing or installing any part
with latches or locking tabs, ensure
that it clicks firmly into place.
P/N 960-000231R_Rev. A
CAUTION
WARNING
CAUTION

Preventive Maintenance

Do not redesign or disassemble the
Unit. Unauthorized use by inade-
quately trained personnel, or use out-
side the original manufacturer's intent
for operation voids the warranty.
Disconnect Main Plug
From Electrical Outlet
Be sure to remove electrical power
from the Unit before beginning a
maintenance procedure. The equip-
ment can produce abnormal operat-
ing signals while in maintenance
mode that may cause personal injury.
If the Unit is exposed to water or other
liquids, use a clean, dry micro-fiber
cloth to wipe off and absorb excess
liquids immediately. Any remaining
liquids may affect and degrade the
Sensors and Validation performance.
•
When reassembling a disassem-
bled unit, ensure that each part is
carefully placed in its proper loca-
tion.
•
Be sure that each part is placed in
the proper location after mainte-
nance.
•
To keep the Unit's performance and
Banknote acceptance at optimal
rates, clean and maintain the Unit
regularly, especially in smoky 
environments such as where exces-
sive Automobile exhaust emission
or Cigarette Smoke may exist
(Refer to "Cleaning" on page 21).
© 2022, JAPAN CASH MACHINE CO., LTD.
4
General Information
WARNING
CAUTION