Hart Communication Interface - Siemens SITRANS F Operating Instructions Manual

3.4

HART Communication Interface

System communication
Table 3- 1
Firmware bundle version
Build date of firmware version
Manufacturer ID
Device type
HART protocol revision
Device revision
Note: Version numbers and other references shown above are typical or example values.
Device description files
Available EDD drivers:
● SIMATIC PDM
● FDT/DTM
● AMS suite
● 375 Field Communicator
The drivers can be downloaded here:
Download EDD drivers (http://www.siemens.com/flowdocumentation)
Configuration of the HART polling address
The HART address can be set either via hardware (DIP switch) or via software (LUI or
SIMATIC PDM).
The DIP switch is located on the transmitter cassette, see position
view" in "Design" (Page 25).
Figure 3-5
SITRANS FC430 with HART
Operating Instructions, 03/2012, A5E03361511-01
HART protocol identification data
1.00.01
01.07.2011
42 (2A Hex)
34 (22 Hex)
7.2
1
HART slave address switch
3.4 HART Communication Interface
On the inner title page of these operating instruction
On the inner title page of these operating instructions
Manufacturer ID parameter
Device type parameter
HART protocol revision parameter
Device revision parameter
Description
⑥
"Transmitter exploded
31