Hart Communication Interface - Siemens SITRANS F Function Manual

HART Communication Interface

2.1 HART Communication Interface
System communication
Table 2-1
Manufacturer ID
Device type
HART protocol revision
Device revision
Note: Version numbers and other references shown above are typical or example values.
Device description files
Available EDD drivers:
● SIMATIC PDM
● FDT/DTM
● AMS suite
● 375 Field Communicator
The drivers can be downloaded here:
Download EDD Files (http://www.siemens.com/flowdocumentation)
Configuration of the HART polling address
The HART address can be set either via hardware (DIP switch) or via software (HMI or
SIMATIC PDM).
The DIP switch is located on the transmitter cassette.
Figure 2-1
FCT030 HART (From firmware 4.0)
Function Manual, 06/2018, A5E39931617-AB
HART protocol identification data
42 (2A Hex)
34 (22 Hex)
7.5
5
HART slave address switch
Manufacturer ID parameter
Device type parameter
HART protocol revision parameter
Device revision parameter
2
7