Changing The Lamp - ACME ORION XP-260 BEAM User Manual

4.3 Changing the Lamp

Do not use this lamp more than 6000 hours, using the lamp any longer than its set life could seriously
damage your unit. Periodically checking the lamp running time, when the lamp reaches the 6000 hour
mark, or close to it, we strongly suggest you switch the lamp out. Clear the RESET TIME after you have
replaced the lamp.
To replace the lamp:
1. Ensure that the fixture is detached from power and has cooled down completely. It is a good idea
to allow the fixture to run for 10 minutes after the lamp has been turned off, so that the cooling
fans have time to works.
2. Loosen the screws on the head of the fixture and open the fixture head covers.
3. Loosen the screw that holds the lamp in place. Unplug the leads of the lamp and lift the lamp out
of its recess, disconnect the lamp and connect a new lamp that must be the same type with the
old one. And then place the new lamp into the lamp recess.
8C