ACME ORION XP-260 BEAM User Manual page 26

4. Tilt Encoder Error
Check if the tilt encoder is damaged.
Check if the tilt encoder is in poor contact with the lead of the PCB board or disconnected.
5. CPU-B/C/D Error
Check whether the 485 (DATA) leads on the PCB board are install in place or disconnected.
Check whether the 485 (DATA) lead is disconnected.
Check whether the relevant signal circuit 485 (DATA) on the PCB board is damaged.
6. Color Reset Fail
Check if the position of the color wheel mounting magnetic steel falls off or is damaged.
Check if there are other interference items in the color wheel operating range.
Check if the color wheel Hall elements is damaged.
Check if the color wheel Hall elements is in poor contact with the lead of the PCB board or
disconnected.
Check if the color wheel motor is damaged.
Check if there is any damage to the circuit of the color wheel motor drive board.
7. Gobo Reset Fail
Check if the position of the gobo wheel mounting magnetic steel falls off or is damaged.
Check if there are other interference items in the gobo wheel operating range.
Check if the gobo wheel Hall elements is damaged.
Check if the gobo wheel Hall elements is in poor contact with the lead of the PCB board or
disconnected.
Check if the gobo wheel motor is damaged.
Check if there is any damage to the circuit of the gobo wheel motor drive board.
8. Prism1/2 Reset Fail
Check if the position of the Prism1/2 mounting magnetic steel falls off or is damaged.
Check if there are other interference items in the Prism1/2 operating range.
Check if the Prism1/2 Hall elements is damaged.
Check if the Prism1/2 Hall elements is in poor contact with the lead of the PCB board or
disconnected.
Check if the Prism1/2 motor is damaged.
Check if there is any damage to the circuit of the Prism1/2 motor drive board.
25C