Installation - HunterLab ColorFlex EZ User Manual

Installation

Before operating the ColorFlex EZ, connect the instrument to a power source, a computer or to
an optional component, such as a printer. Instructions are provided below.
1. Unpack the cartons and remove wrappings and cable ties. Inspect for damage and
notify the carrier and HunterLab immediately if any is discovered. Save the packing
materials in case it becomes necessary to return the instrument to the factory.
2. Place the ColorFlex EZ on a flat, stable surface near and electrical outlet.
3. Connect the connector of the AC adapter to the acceptor on the left back of the
ColorFlex EZ.
4. Plug the female end of the power cord into the AC Adapter and the male end into a
wall outlet.
5. If the instrument is to be used connected to a computer, printer, or other USB
device, plug the hexagonal end of the USB cable into the USB port on the ColorFlex
EZ.
6. Plug the flat end of the USB cable into the appropriate USB port on the computer or
device. If connecting to a computer, Windows' plug and play feature should
automatically find and install the ColorFlex EZ. Let it do so until the FOUND NEW
HARDWARE message disappears. Other devices, such as the printer, bar code
reader, and keyboard, are automatically detected by the ColorFlex EZ.
7. Turn the ColorFlex EZ on by pressing the GO (lightning bolt ) button on the button
pad.
8
ColorFlex EZ User's Manual Version 2.2